Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G3500, VAN PASSENGER EXTENDEDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 612 (REAR DRIVE AXLE)COMPONENT LOCATORREAR AXLE DISASSEMBLED VIEWS
2008 Chevrolet Chevy Express G3500, Van Passenger Extended
Rear Axle Disassembled Views
2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Rear Axle Disassembled Views
WARNING: This page is about a different car, the 2010 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
| Callout | Component Name |
|---|---|
| 1 | Differential Carrier |
| 2 | Carrier Cover |
| 3 | Pinion Bearing Cage |
| 4 | Nut |
| 5 | Flange |
| 6 | Pinion Oil Seal |
| 7 | Bearing |
| 8 | Cup |
| 9 | Bolt |
| 10 | Shim |
| 11 | O-ring Seal |
| 12 | Pinion Bearing Spacer |
| 13 | Cup |
| 14 | Bearing |
| 15 | Support Bushing |
| 16 | Axle Oil Seal |
| 16 | Axle Oil Seal |
| 17 | Drain Plug |
| 18 | Shim |
| 18 | Shim |
| 19 | Cup |
| 19 | Cup |
| 20 | O-ring Seal |
| 21 | Vent |
| 22 | Fill Plug |
| 23 | Bolt |
| 24 | Fill Plug Washer |
| 100 | Differential Assembly |
| 110 | Pinion Gear |
| Callout | Component Name |
|---|---|
| 101 | Bearing |
| 101 | Bearing |
| 102 | Bolt |
| 104 | Differential Case |
| 105 | Ring Gear |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.