Rear Side Marker Lamp Replacement

2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Rear Side Marker Lamp Replacement
WARNING: This page is about a different car, the 2010 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Rear Side Marker Lamp
GM1829342Courtesy of GENERAL MOTORS CORP.
Callout Component Name
Preliminary Procedure:Β 
Remove the inner wheelhouse liner. Refer to Rear Wheelhouse Panel Liner Replacement .
1 Rear Side Marker Lamp

Procedure

  1. Squeeze the attachment clip with the fingers or a suitable pair of flat-tipped pliers.
  2. Push the lamp assembly outward from the rear bumper fascia in order to remove.
  3. Disconnect the lamp socket from the lamp housing.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.