Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G3500, VAN PASSENGER EXTENDEDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 589 (INTERIOR TRIM SYSTEM AND PANELING)REPAIR INSTRUCTIONSREAR WINDOW SHELF TRIM PANEL REPLACEMENTINSTALLATION PROCEDURE

2008 Chevrolet Chevy Express G3500, Van Passenger Extended

Installation Procedure

2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Installation Procedure

WARNING: This page is about a different car, the 2010 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Lock Fasteners & Shelf Panel

Courtesy of GENERAL MOTORS CORP.

Route the rear seat shelf panel (2) to the rear cross car beam at the dual lock fasteners (1).
Position the rear center shoulder belt through the rear shelf panel.
Ensure the shoulder belt is not twisted.
Lower the rear shelf panel over the child restraint tether anchors and apply pressure at both dual lock fasteners (1) to secure.

Fig 2: Shoulder Belt Escutheon

Courtesy of GENERAL MOTORS CORP.

Secure the shoulder belt escutheon to the rear shelf panel.
Insert the escutheon rearward and snap the front downward in place to secure.
Install both rear upper quarter sail panels. Refer to Sail Panel Replacement .
Install the rear seat back. Refer to Rear Seat Back Cushion Replacement .
Install the rear seat cushion. Refer to Rear Seat Cushion Replacement .

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.