Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G3500, VAN PASSENGER EXTENDEDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 589 (INTERIOR TRIM SYSTEM AND PANELING)REPAIR INSTRUCTIONSPRESSURE RELIEF VALVE REPLACEMENTINSTALLATION PROCEDURE

2008 Chevrolet Chevy Express G3500, Van Passenger Extended

Installation Procedure

2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Installation Procedure

WARNING: This page is about a different car, the 2010 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Pressure Relief Valve

Courtesy of GENERAL MOTORS CORP.

Position the pressure relief valve to the opening in the rear quarter panel.
Press inward on the pressure relief valve until fully seated.
Install the rear bumper fascia.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.