Installation Procedure

2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Installation Procedure
WARNING: This page is about a different car, the 2010 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Inflatable Restraint Side Impact Module Wiring Harness
    GM513378Courtesy of GENERAL MOTORS CORP.
  1. Install the new side impact module wiring harness (3) to the seat (1).
  2. Install the retaining clips that fasten the side impact module wiring harness (3) to the seat (1).
  3. Install the side impact module (2) to the seat (1). Refer to Driver or Passenger Seat Side Inflatable Restraint Module ReplacementΒ .
  4. Install the seat back panel.
  5. Enable the SIR system. Refer to SIR Disabling and EnablingΒ .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.