SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G3500, VAN PASSENGER EXTENDEDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 540 (AUTOMATIC TRANSMISSION - 4L60-E - INTRODUCTION)SPECIFICATIONSRANGE REFERENCE
2008 Chevrolet Chevy Express G3500, Van Passenger Extended

Range Reference

2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Range Reference
WARNING: This page is about a different car, the 2009 GMC Savana and 2009 Chevrolet Chevy Express. However, it is still accessible from the selected car via links, so may be relevant.
Range Reference Table

Range Park Reverse Neutral OD D 2 1
Gear       1st 2nd 3rd 4th 1st 2nd 3rd 1st** 2nd 1st 2nd***
1-2 Shift Solenoid  ON* ON* ON* ON OFF OFF ON ON OFF OFF ON OFF ON OFF
2-3 Shift Solenoid  ON* ON* ON* ON ON OFF OFF ON ON OFF ON ON ON ON
2-4 Band  - - - - A - A - A - - A - A
Reverse Input Clutch  - A - - - - - - - - - - - -
Overrun Clutch  - - - - - - - - - A A A A A
Forward Clutch  - - - A A A A A A A A A A A
Forward Sprag Clutch Assembly  - - - H H H - H H H H H H H
3-4 Clutch  - - - - - A A - - A - - - -
Lo/Roller Clutch  - - - H - - - H - - H - H -
Lo/Rev Clutch  A A - - - - - - - - - - A -
  • A = Applied
  • H = Holding
  • ON = The solenoid is energized.
  • OFF = The solenoid is de-energized.
  • *Shift Solenoid state is a function of vehicle speed and may change if the vehicle speed increases sufficiently in Park, Reverse or Neutral. However, this does not affect the operation of the transmission.
  • **Manual Second-First gear is electronically prevented under normal operating conditions.
  • ***Manual First-Second gear is only available above approximately 48-56 km/h (30-35 mph).
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.