Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G3500, VAN PASSENGER EXTENDEDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 538 (ENGINE CONTROL SYSTEM & FUEL SYSTEM - 6.6L LMM - INTRODUCTION)REPAIR INSTRUCTIONSTURBOCHARGER LEARNLEARN PROCEDURE WITH THE TECH 2
2008 Chevrolet Chevy Express G3500, Van Passenger Extended
Learn Procedure With the Tech 2
2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Learn Procedure With the Tech 2
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2009 GMC Savana Special, 2009 GMC Savana Camper Special, 2009 GMC Savana, 2009 Chevrolet RV Cutaway, and 2009 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Once the enable conditions have been met the throttle must remain at idle. Do not change the accelerator pedal position (APP) during this procedure.
- The following conditions must be met for the ECM to perform the turbocharger learn procedure:
- The A/C is OFF.
- The vehicle is in Park or Neutral.
- Start and idle the engine.
- The engine coolant temperature (ECT) is greater than 40°C (104°F).
- After the enable conditions have been met and the engine idle is stabilized, enter the TC Learn Output function from the Module Setup Menu. Command the TC Learn ON for at least 5 seconds, then command it OFF. The system should have learned the new turbocharger position. The TC Vane Pos. Lrn This Run Cycle parameter should have toggled from No to Yes.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.