Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G3500, VAN PASSENGER EXTENDEDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 538 (ENGINE CONTROL SYSTEM & FUEL SYSTEM - 6.6L LMM - INTRODUCTION)REPAIR INSTRUCTIONSFUEL INJECTION FUEL FEED FRONT PIPE REPLACEMENT - LEFT SIDEREMOVAL PROCEDURE
2008 Chevrolet Chevy Express G3500, Van Passenger Extended
Removal Procedure
2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Removal Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2009 GMC Savana Special, 2009 GMC Savana Camper Special, 2009 GMC Savana, 2009 Chevrolet RV Cutaway, and 2009 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the air conditioning (A/C) compressor. Refer to Air Conditioning Compressor Replacement (4.3L) or Air Conditioning Compressor Replacement (4.8L, 5.3L, 6.0L) or Air Conditioning Compressor Replacement (6.6L) .
- If equipped, remove the auxiliary generator. Refer to Auxiliary Generator Replacement .
- Disconnect the fuel feed pipe fitting from the fuel injector pump.
- Disconnect the fuel feed pipe fitting from the left fuel rail.
- Remove the left fuel feed pipe.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.