Exhaust Gas Recirculation Valve Temperature Sensor Replacement - Position 2

2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Exhaust Gas Recirculation Valve Temperature Sensor Replacement - Position 2
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2009 GMC Savana Special, 2009 GMC Savana Camper Special, 2009 GMC Savana, 2009 Chevrolet RV Cutaway, and 2009 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Exhaust Gas Recirculation Valve Temperature Sensor Replacement - Position 2
GM1998258Courtesy of GENERAL MOTORS CORP.
Callout Component Name

Preliminary Procedures

  1. Remove the engine cover.
  2. Remove the air cleaner. Refer to Air Cleaner Assembly ReplacementΒ .
1 EGR Temperature Sensor Assembly
CAUTION: Refer to Fastener Caution .

Procedure

  1. Disconnect the harness connector.
  2. Detach the EGR temperature sensor assembly harness connector from the bracket.


Tighten:Β  44 N.m (32 lb ft)

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.