Removal Procedure

2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Removal Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2009 GMC Savana Special, 2009 GMC Savana Camper Special, 2009 GMC Savana, 2009 Chevrolet RV Cutaway, and 2009 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Chassis Wiring Harness Electrical Connector & Fuel Pump Flow Control Module
    GM1931044Courtesy of GENERAL MOTORS CORP.
  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Disconnect the chassis wiring harness electrical connector (2) from the fuel pump flow control module (1).
  3. Fig 2: View Of Fuel Pump Flow Control Module & Bolts
    GM1931045Courtesy of GENERAL MOTORS CORP.

    Remove the fuel pump flow control module bolts (1).
  4. Remove the fuel pump flow control module (2) from the frame.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.