Removal Procedure

2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Removal Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2009 GMC Savana Special, 2009 GMC Savana Camper Special, 2009 GMC Savana, 2009 Chevrolet RV Cutaway, and 2009 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the passenger seat from the vehicle. Refer to Driver or Passenger Seat Replacement .
  2. Pull the carpet back to gain access to the sensor.
  3. Fig 1: Yaw Rate Sensor/Lateral Accelerometer, Nuts & Electrical Connector
    GM1372891Courtesy of GENERAL MOTORS CORP.
  4. Remove the nuts (2) from the yaw rate sensor and lateral accelerometer.
  5. Disconnect the electrical connector (3) from the yaw rate sensor/lateral accelerometer.
  6. Remove the yaw rate sensor and lateral accelerometer (1) from the vehicle.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.