Removal Procedure

2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Removal Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2009 GMC Savana Special, 2009 GMC Savana Camper Special, 2009 GMC Savana, 2009 Chevrolet RV Cutaway, and 2009 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
    WARNING: Refer to SIR Warning .
  1. Disable the SIR system. Refer to SIR Disabling and Enabling .
  2. Remove the ignition switch. Refer to Ignition and Start Switch Replacement .
  3. Remove the turn signal cancel cam. Refer to Steering Column Tilt Head Housing Replacement .
  4. Remove the park lock cable from the lock cylinder housing.
  5. Fig 1: View Of Lock Cylinder Housing TORX Screws
    GM1413838Courtesy of GENERAL MOTORS CORP.
  6. Remove 3 TORX® screws.
  7. Remove the lock cylinder housing from the steering column.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.