Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G3500, VAN PASSENGER EXTENDEDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 51 (POWER STEERING SYSTEM)REPAIR INSTRUCTIONSPOWER STEERING PUMP FLOW CONTROL VALVE REPLACEMENT - OFF VEHICLE
2008 Chevrolet Chevy Express G3500, Van Passenger Extended
Power Steering Pump Flow Control Valve Replacement - Off Vehicle
2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Power Steering Pump Flow Control Valve Replacement - Off Vehicle
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Power Steering Pump Flow Control Valve Replacement - Off Vehicle
| Callout | Component Name |
|---|---|
| 1 | Power Steering Pump Reservoir Tip: Drain the power steering fluid from the reservoir. |
| 2 | Flow Control Valve Fitting
NOTE:
Refer to Fastener Notice
.
Tighten: 75 N.m (55 lb ft) |
| 3 | Flow Control Valve Fitting Seal Tip: Prior to installation, apply power steering fluid to the seal. |
| 4 | Flow Control Valve |
| 5 | Flow Control Valve Spring |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.