Turn Signal Multifunction Switch Replacement

2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Turn Signal Multifunction Switch Replacement
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2009 GMC Savana Special, 2009 GMC Savana Camper Special, 2009 GMC Savana, 2009 Chevrolet RV Cutaway, and 2009 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Multifunction Turn Signal Switch & Screws
GM1701070Courtesy of GENERAL MOTORS CORP.
Callout Component Name
Preliminary Procedure:Β 
Remove the steering column trim covers. Refer to Steering Column Trim Cover ReplacementΒ .
1 Turn Signal Multifunction Switch Bolt (Qty: 2)
CAUTION: Refer to Fastener Caution .

Tighten:Β  3 N.m (27 lb in)

2 Turn Signal Multifunction Switch
Procedure:Β 
Disconnect any electrical connectors as needed.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.