Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G3500, VAN PASSENGER EXTENDEDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 499 (STEERING WHEEL & STEERING COLUMN)REPAIR INSTRUCTIONSTRANSMISSION CONTROL REPLACEMENT

2008 Chevrolet Chevy Express G3500, Van Passenger Extended

Transmission Control Replacement

2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Transmission Control Replacement

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2009 GMC Savana Special, 2009 GMC Savana Camper Special, 2009 GMC Savana, 2009 Chevrolet RV Cutaway, and 2009 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View of Linear Shift Assembly

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure: Remove the shift lever. Refer to Shift Lever Replacement .
1	Automatic Transmission Shift Lock Control Actuator Procedure Use the appropriate tool to remove the automatic transmission shift lock control actuator. After repairs, the automatic transmission shift lock control actuator may need to be adjusted. Refer to Automatic Transmission Shift Lock Control Actuator Replacement .
2	Transmission Control Bolt (Qty: 3) CAUTION: Refer to Fastener Caution . Tighten: 10 N.m (89 lb in)
3	Transmission Control Procedure: Turn the ignition lock cylinder to the OFF-LOCK position and remove the park lock cable from the ignition lock cylinder case.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.