Removal Procedure

2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Removal Procedure
WARNING: This page is about a different car, the 2009 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the left lower front bumper close out panel. Refer to Front Air Deflector Replacement .
  3. Fig 1: View Of Engine Oil Cooler Hose/Pipe
    GM1739056Courtesy of GENERAL MOTORS CORP.
  4. Install oil drain pan under the vehicle.
  5. Remove the engine oil cooler hose/pipe from the external oil cooler. Refer to Engine Oil Cooler Hose/Pipe ReplacementΒ .
  6. Fig 2: View Of External Engine Oil Cooler Quick Connect Fitting
    GM1739075Courtesy of GENERAL MOTORS CORP.
  7. Remove the external engine oil cooler quick connect fitting.
  8. Remove and discard all engine oil cooler hose/pipe seals.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.