Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G3500, VAN PASSENGER EXTENDEDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 431 (ANTILOCK BRAKE SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESDIAGNOSTIC CODE INDEX
2008 Chevrolet Chevy Express G3500, Van Passenger Extended
Diagnostic Code Index
2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Diagnostic Code Index
WARNING: This page is about a different car, the 2009 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSTIC CODE INDEX
| DTC | Description |
|---|---|
| DTC C0035-C0050 | C0035 02: Left Front Wheel Speed Sensor Circuit Short to Ground C0035 05: Left Front Wheel Speed Sensor Circuit Short to Battery or Open C0035 0F: Left Front Wheel Speed Sensor Circuit Erratic Signal C0035 18: Left Front Wheel Speed Sensor Circuit Signal Amplitude Less Than Minimum C0040 02: Right Front Wheel Speed Sensor Circuit Short to Ground C0040 05: Right Front Wheel Speed Sensor Circuit Short to Battery or Open C0040 0F: Right Front Wheel Speed Sensor Circuit Erratic Signal C0040 18: Right Front Wheel Speed Sensor Circuit Signal Amplitude Less Than Minimum C0045 02: Left Rear Wheel Speed Sensor Circuit Short to Ground C0045 05: Left Rear Wheel Speed Sensor Circuit Short to Battery or Open C0045 0F: Left Rear Wheel Speed Sensor Circuit Erratic Signal C0045 18: Left Rear Wheel Speed Sensor Circuit Signal Amplitude Less Than Minimum C0050 02: Right Rear Wheel Speed Sensor Circuit Short to Ground C0050 05: Right Rear Wheel Speed Sensor Circuit Short to Battery or Open C0050 0F: Right Rear Wheel Speed Sensor Circuit Erratic Signal C0050 18: Right Rear Wheel Speed Sensor Circuit Signal Amplitude Less Than Minimum |
| DTC C0110 | C0110 04: Pump Motor Circuit Open Circuit C0110 03: Pump Motor Circuit Voltage Below Threshold C0110 61: Pump Motor Circuit Actuator Stuck |
| DTC C0131 | C0131 01: ABS Pressure Circuit Short to Battery C0131 06: ABS Pressure Circuit Short to Ground or Open C0131 4B: ABS Pressure Circuit Calibration Not Learned C0131 55: ABS Pressure Circuit Expected Number of Transition/Events exceeded C0131 5A: ABS Pressure Circuit Plausibility Failure C0131 0F: ABS Pressure Circuit Erratic |
| DTC C0161 | C0161 5A: Antilock Brake System (ABS) Brake Switch Circuit Plausibility Failure |
| DTC C0179 | C0179 54: System Thermal Temperature High |
| DTC C0186 or C0196 | C0186 09: Lateral Accelerometer Circuit Rate of Change Above Threshold C0186 1A: Lateral Accelerometer Circuit Bias Level Out Of Range C0186 3B: Lateral Accelerometer Circuit Erratic Internal Self Test Failed C0186 75: Lateral Accelerometer Circuit Signal Above Allowable Range C0196 09: Yaw Rate Circuit Rate of Change Above Threshold C0196 1A: Yaw Rate Circuit Bias Level Out Of Range C0196 3B: Yaw Rate Sensor Internal Self Test Failed C0196 75: Yaw Rate Circuit Signal Above Allowable Range |
| DTC C0201 | C0201 04: Antilock Brake System (ABS) Enable Relay Contact Open Circuit |
| DTC C0242 | C0242 00: ECM Indicated TCS Malfunction C0242 71: ECM Indicated TCS Malfunction, Invalid Serial Data C0242 75: ECM Indicated TCS Malfunction, Signal Above Allowable Range |
| DTC C0245 | C0245 5A: Wheel Speed Sensor Plausibility Failure |
| DTC C0292 | C0292 07: VSES Combination Sensor Circuit Voltage Above or Below Threshold |
| DTC C0550 | C0550 00: Electronic Control Unit (ECU) Performance |
| DTC C0558 | C0558 46: Calibration Data Not Programmed/Learned, vehicle configuration not programmed |
| DTC C0561 | C0561 71: System Disabled Information Stored Invalid Serial Data Recieved C0561 72: System Disabled Information Stored Alive Counter Incorrect/Not Updated C0561 74: System Disabled Information Stored Value of Signal Protection Calculation Incorrect C0561 75: System Disabled Information Stored Value of Signal Above Allowable Range C0561 7F: System Disabled Information Stored Value of Signal Erratic |
| DTC C0710 | C0710 55: Steering Position Signal expected number of transitions/events not reached C0710 4B: Steering Position Signal Calibration not Learned C0710 5A: Steering Position Signal Plausibility Failure C0710 0F: Steering Position Signal Erratic C0710 17: Steering Position Signal Signal Shape/ Waveform Failure |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.