Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Circuit/System Description
The console active antenna is located in the center console and is used to establish low frequency (LF) communications with the keyless entry transmitter The keyless entry console active antenna is only used when the console passive antenna was unable to locate a transmitter within the interior of the vehicle. This may be due to a keyless entry transmitter battery being low or RF/LF interference.
When a valid transmitter is placed into the pocket located in the center console, and either the brake pedal is depressed or the ignition control knob is pressed, the console active antenna broadcasts a challenge to the transmitter. This causes a low frequency coupling to occur between the transmitter and the console active antenna. If the response from the transmitter is a valid response, and all of the security requirements are met, the vehicle's engine will start, or be allowed to go into accessory mode.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.