Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G3500, VAN PASSENGER EXTENDEDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 410 (BATTERY, CHARGING SYSTEM AND STARTING SYSTEM)REPAIR INSTRUCTIONSSTARTER MOTOR REPLACEMENT (LLT)INSTALLATION PROCEDURE

2008 Chevrolet Chevy Express G3500, Van Passenger Extended

Installation Procedure

2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Installation Procedure

WARNING: This page is about a different car, the 2009 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Starter Motor - LY7

Courtesy of GENERAL MOTORS CORP.

Install the starter motor.

CAUTION: Refer to Fastener Caution .

Install the starter motor mounting bolts and tighten to 50 N.m (37 lb ft).

Fig 2: View Of Starter Terminal Nut & Battery Positive Cable

Courtesy of GENERAL MOTORS CORP.

Install the battery positive cable (2) to the starter and install the starter terminal nut (1) and tighten to 13 N.m (115 lb in).

Fig 3: View Of Starter Solenoid Electrical Connector

Courtesy of GENERAL MOTORS CORP.

Install the electrical connector to the starter solenoid.
Install the left catalytic converter. Refer to Catalytic Converter Replacement - Left Side .

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.