Installation Procedure

2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Installation Procedure
WARNING: This page is about a different car, the 2009 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Windshield Wiper & Washer Switch
    GM428823Courtesy of GENERAL MOTORS CORP.
  1. Install the windshield wiper and washer switch (1) to the steering column.
  2. Fig 2: View Of Windshield & Washer Switch Electrical Connectors
    GM293230Courtesy of GENERAL MOTORS CORP.
  3. Connect the electrical connectors (1, 3) on the windshield wiper and washer switch.
  4. Route and connect the electrical connector from the windshield wiper and washer switch.
  5. Install the wiring harness tie straps.
  6. Install the steering column trim covers. Refer to Steering Column Trim Covers Replacement .
  7. Enable the SIR system. Refer to SIR Disabling and Enabling .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.