Front Side Turn Signal Lamp Replacement (STS-V)

2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Front Side Turn Signal Lamp Replacement (STS-V)
WARNING: This page is about a different car, the 2009 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View of Front Side Turn Signal Lamp
GM2094215Courtesy of GENERAL MOTORS CORP.
Callout Component Name

Preliminary Procedure

  1. Apply masking tape to the rear edge of the front side turn signal lamp.
  2. Using a small flat-bladed tool, gently pry at the rear edge of the lamp assembly.
  3. Carefully rotate the lamp forward in order to remove the lamp from the fender opening.
1 Front Side Turn Signal Lamp
Tip:Β  Rotate the bulb socket and remove the socket from the lamp assembly.
2 Front Side Turn Signal Lamp Bulb
WARNING: Refer to Halogen Bulb Warning .

Remove the bulb from the lamp socket, if applicable.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.