Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G3500, VAN PASSENGER EXTENDEDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 396 (INSTRUMENT PANEL TRIM AND CONSOLE TRIM)REPAIR INSTRUCTIONSINSTRUMENT PANEL INSULATOR PANEL REPLACEMENT - LEFT SIDEINSTALLATION PROCEDURE
2008 Chevrolet Chevy Express G3500, Van Passenger Extended
Installation Procedure
2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Installation Procedure
WARNING: This page is about a different car, the 2009 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
- Connect the courtesy lamp electrical connector (2).
- Locate the insulator panel onto the Instrument panel.
- Install the screws securing the instrument panel and tighten to 2 N.m (18 lb in).
CAUTION:
Refer to Fastener Caution
.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.