Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Circuit/System Description
The transmission contains two electric motor generators. The drive motor generators are cooled by the transmission fluid. Hot fluid exits the drive motor generator housing and flows to the transmission cooler supply line. The supply line connects to the cooler. From the cooler, the fluid returns through the oil cooler return line and enters the lubrication circuits. After lubricating the internal components, the fluid returns to the oil pan. A non-serviceable motor temperature sensor (MTS) is located in each drive motor generator assembly.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.