SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G3500, VAN PASSENGER EXTENDEDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 325 (POWER STEERING SYSTEM)REPAIR INSTRUCTIONSSTEERING LINKAGE OUTER TIE ROD REPLACEMENT
2008 Chevrolet Chevy Express G3500, Van Passenger Extended

Steering Linkage Outer Tie Rod Replacement

2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Steering Linkage Outer Tie Rod Replacement
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Steering Linkage Outer Tie Rod Components
GM1824881Courtesy of GENERAL MOTORS CORP.
Callout Component Name
Preliminary Procedure: 
Remove the front tire/wheel. Refer to Tire and Wheel Removal and Installation .
1 Steering Linkage Outer Tie Rod Nut
NOTE: Refer to Fastener Notice .

Tighten:  60 N.m (44 lb ft)
2 Steering Linkage Inner Tie Rod Nut

Tighten:  75 N.m (55 lb ft)
3 Steering Linkage Outer Tie Rod

Procedure

  1. Use puller J 24319-B  to separate the steering linkage outer tie rod from the steering knuckle. See Special Tools .
  2. Inspect the steering linkage inner tie rod for bent or damaged threads.
  3. Clean the tapered surface of the steering knuckle.
  4. Lubricate the steering linkage inner tie rod threads with chassis lubricant. Refer to Fluid and Lubricant Recommendations .
  5. Adjust the front toe. Refer to Front Toe Adjustment .

Special Tools: 
J 24319-B  Steering Linkage and Tie Rod Puller. See Special Tools .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.