Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G3500, VAN PASSENGER EXTENDEDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 325 (POWER STEERING SYSTEM)REPAIR INSTRUCTIONSPOWER STEERING FLUID COOLER REPLACEMENT (WITHOUT HYDROBOOST)REMOVAL PROCEDURE
2008 Chevrolet Chevy Express G3500, Van Passenger Extended
Removal Procedure
2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Removal Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the fascia grille. Refer to Fascia Grille Replacement (Z71) or Fascia Grille Replacement (Suburban, Tahoe) or Fascia Grille Replacement (Escalade) or Fascia Grille Replacement (Yukon) or Fascia Grille Replacement (GMC Yukon Two-mode Hybrid) .
- Remove the radiator grille reinforcement support, if equipped. Refer to Radiator Grille Reinforcement Support Replacement .
- Remove as much power steering fluid as possible from the power steering fluid reservoir.
- Place drain pans under the vehicle as needed.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.