Removal Procedure

2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Removal Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Rearview Mirror Electrical Connector
    GM787027Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the electrical connector from the back of the mirror.
  2. Remove the wire cover.
  3. Adjust the mirror to the full upward position.
  4. Remove the base trim cover.
  5. Fig 2: View Of Rearview Mirror Mounting Components
    GM787028Courtesy of GENERAL MOTORS CORP.
  6. Loosen the screw (3) in order to remove the mirror (2) from the button assembly (1).
  7. Slide the mirror assembly in an upward motion in order to remove.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.