SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G3500, VAN PASSENGER EXTENDEDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 282 (INTERIOR TRIM AND PANELING)REPAIR INSTRUCTIONSARMREST REPLACEMENT
2008 Chevrolet Chevy Express G3500, Van Passenger Extended

Armrest Replacement

2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Armrest Replacement
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Front Side Door Armrest Assembly & Components
GM1693724Courtesy of GENERAL MOTORS CORP.
Callout Component Name

Preliminary Procedures

  1. Remove door upper trim panel. Refer to Upper Extension Trim Panel Replacement (Escalade)  or Upper Extension Trim Panel Replacement (Except Escalade) .
  2. Remove door window control switch. Refer to Door Lock and Side Window Switch Replacement - Driver Side or Door Lock and Side Window Switch Replacement - Passenger Side .
  3. Remove door trim panel. Refer to Front Side Door Trim Panel Replacement .
1 Front Side Door Armrest Bolts (Qty: 4)
NOTE: Refer to Fastener Notice .

Tighten:  2 N.m (18 lb in)
2 Front Side Door Trim Panel Bolts (Qty: 7)

Tighten:  2 N.m (18 lb in)
3 Front Side Door Armrest Assembly
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.