Tail Lamp Replacement (Avalanche)

2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Tail Lamp Replacement (Avalanche)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Tail Lamp Assembly & Components
GM1739484Courtesy of GENERAL MOTORS CORP.
Callout Component Name
Preliminary Procedure:Β 
Open the endgate in order to access the tail lamp assembly screws.
1 Tail Lamp Assembly Screw (Qty: 2)
NOTE: Refer to Fastener Notice .

Tighten:Β  2 N.m (18 lb in)

2 Tail Lamp Wiring Harness Assembly Connector
3 Tail Lamp Assembly
Tip:Β  Upon installation, push inward on the tail lamp in order to seat the 2 locating pins in the body panel.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.