SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G3500, VAN PASSENGER EXTENDEDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 232 (SUSPENSION CONTROL SYSTEM - AUTOMATIC LEVEL CONTROL)REPAIR INSTRUCTIONSAUTOMATIC LEVEL CONTROL SENSOR AND BRACKET REPLACEMENT (REAR)REMOVAL PROCEDURE
2008 Chevrolet Chevy Express G3500, Van Passenger Extended

Removal Procedure

2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Removal Procedure
WARNING: This page is about a different car, the 2008 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation .
  3. Disconnect the rear ride sensor link from the upper control arm ball stud.
  4. Disconnect the rear ride sensor harness connector.
    5. Fig 1: View Of Rear Ride Sensor
    GM1371666Courtesy of GENERAL MOTORS CORP.
  5. Loosen the rear ride sensor retaining nut.
  6. Gently tap the rear ride sensor retaining stud in order to loosen the stud to fender connection.
  7. Remove the rear ride sender from the vehicle.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.