Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G3500, VAN PASSENGER EXTENDEDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 228 (POWER SEAT SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESLUMBAR SUPPORT INOPERATIVE (W/A45)CIRCUIT/SYSTEM VERIFICATION
2008 Chevrolet Chevy Express G3500, Van Passenger Extended
Circuit/System Verification
2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Circuit/System Verification
WARNING: This page is about a different car, the 2008 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition ON, observe the scan tool lumbar upward switch parameter while operating the lumbar switch to the UPWARD position. The reading should change between ACTIVE and INACTIVE.
- If the reading does not change as the switch is operated, refer to Lumbar Adjuster Switch Malfunction.
- Observe the scan tool lumbar forward switch parameter while operating the lumbar switch to the FORWARD position. The reading should change between ACTIVE and INACTIVE.
- If the reading does not change as the switch is operated, refer to Lumbar Adjuster Switch Malfunction.
- Observe the scan tool lumbar downward switch parameter while operating the lumbar switch to the DOWNWARD position. The reading should change between ACTIVE and INACTIVE.
- If the reading does not change as the switch is operated, refer to Lumbar Adjuster Switch Malfunction.
- Observe the scan tool lumbar rearward switch parameter while operating the lumbar switch to the REARWARD position. The reading should change between ACTIVE and INACTIVE.
- If the reading does not change as the switch is operated, refer to Lumbar Adjuster Switch Malfunction.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.