Circuit/System Verification

2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Circuit/System Verification
WARNING: This page is about a different car, the 2008 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: Verify that B3794 is not set as current or history before performing this diagnostic. If B3794 is set as current or history, go to DTC B3794Β .

Engine ON, observe the scan tool Cruise parameter while pressing each of the cruise control switches. The Counts should match with the table below, as the applicable switch is pressed.

Switch Function Resistance Value Range (Ξ©) Counts
OFF O.L. 0
On 7.8-8.6K Ξ© 29
Resume 2.7-3.0K Ξ© 76
Set 1.2-1.3K Ξ© 148
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.