Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G3500, VAN PASSENGER EXTENDEDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 213 (SUNROOF SYSTEM)REPAIR INSTRUCTIONSSUNROOF PANEL SIDE OPENING COVER REPLACEMENTREMOVAL PROCEDURE

2008 Chevrolet Chevy Express G3500, Van Passenger Extended

Removal Procedure

2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Removal Procedure

WARNING: This page is about a different car, the 2008 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing & Installing Sunroof Panel Side Opening Cover

Courtesy of GENERAL MOTORS CORP.

Open the sunshade to the full rearward position.
Open the sunroof window (1) to the vent position.
Detach both sides of the sunroof side opening closeout panel covers (6) from the sunroof window clips (2).
Open the sunroof to the full open position.
Using a flat-bladed tool, press the locking tab (4) outward, from inside the roof opening, in order to detach the side opening closeout panel cover from the sunroof track channel (3).
With the lock tab (4) depressed, lift the front edge of the side opening closeout panel cover from the track, working towards the rear of the sunroof opening.
Repeat the steps for the entire length of the side opening closeout panel cover (6).
Remove the sunroof side opening closeout panel cover from the sunroof module track assembly.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.