Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DBβ LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G3500, VAN PASSENGER EXTENDEDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 212 (ANTI-LOCK BRAKE SYSTEM, TRACTION CONTROL SYSTEM & STABILITY CONTROL SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESDTC C0710 (WITHOUT JL7)DIAGNOSTIC AIDS
2008 Chevrolet Chevy Express G3500, Van Passenger Extended
Diagnostic Aids
2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Diagnostic Aids
WARNING: This page is about a different car, the 2008 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
- Inspect the vehicle for proper alignment. The car should not pull in either direction while driving straight on a level surface.
- The Snapshot function on the scan tool can help find an intermittent DTC.
- Possible causes for this DTC are the following conditions:
- One of the steering wheel position sensor inputs are open, shorted to ground, or shorted to battery.
- Internal steering angle sensor malfunction
- Noise on the steering wheel position signal circuits
- Yaw and lateral acceleration sensor malfunction causing drifting signal outputs
- Internal EBCM malfunction
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.