Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G3500, VAN PASSENGER EXTENDEDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 212 (ANTI-LOCK BRAKE SYSTEM, TRACTION CONTROL SYSTEM & STABILITY CONTROL SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESDTC C0710 (WITHOUT JL7)CONDITIONS FOR RUNNING THE DTC
2008 Chevrolet Chevy Express G3500, Van Passenger Extended
Conditions for Running the DTC
2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Conditions for Running the DTC
WARNING: This page is about a different car, the 2008 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
C0710 00
- The ignition is ON.
- Ignition voltage is greater than 8 volts.
- The steering wheel position sensor has been powered ON for 0.2 second.
C0710 1A
- The ignition is ON.
- Ignition voltage is greater than 8 volts.
- The steering wheel position sensor is centered.
C0710 1F
- The ignition is ON.
- Ignition voltage is greater than 8 volts.
- The steering wheel position sensor has been powered ON for 0.2 second.
- The steering rate of position signal A is less than 80 degrees per second.
C0710 52
- The ignition is ON.
- Ignition voltage is greater than 8 volts.
- The steering wheel position sensor has been powered ON for 0.2 second.
- The steering wheel position sensor is centered.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.