Ignition Lock Key Transmitter Antenna Replacement - Floor Console (Rear)

2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Ignition Lock Key Transmitter Antenna Replacement - Floor Console (Rear)
WARNING: This page is about a different car, the 2008 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Floor Console Wiring Harness Assembly
GM1836059Courtesy of GENERAL MOTORS CORP.
Callout Component Name

Preliminary Procedure

  1. Remove HVAC ducts from the front floor console. Refer to Front Floor Console Cup Holder Replacement
  2. Remove the center console end panel. Refer to Center Console End Panel Replacement
1 Front Floor Console Wiring Harness Assembly
2 Ignition Lock Key Transmitter Antenna Nut (Qty: 4)
NOTE: Refer to Fastener Notice .

Tighten:Β  2 N.m(18 lb in)

3 Ignition Lock Key Transmitter Antenna Assembly
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.