Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Vehicle Stability Control Module Programming and Setup
Vehicle Stability Control Module (VSCM) Replacement and Setup
The following service procedures require either a programming or a setup event performed for a complete repair.
If the vehicle stability control module (VSCM) is replaced, the following procedures must be performed in the following order:
- VSCM Reprogramming--Refer to Service Programming System (SPS) .
- Revise the steering position sensor centering setup procedure using the Scan Tool module setup function.
- Revise the acceleration sensor reset procedure using the Scan Tool module setup function
- Revise the VSCM power steering reset procedure using the Scan Tool module setup function.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.