Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G3500, VAN PASSENGER EXTENDEDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 204 (VEHICLE DIAGNOSTIC INFORMATION)SPECIFICATIONSCRUISE CONTROL MODULE WITH DISTANCE SENSING SCAN TOOL INFORMATION
2008 Chevrolet Chevy Express G3500, Van Passenger Extended
Cruise Control Module with Distance Sensing Scan Tool Information
2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Cruise Control Module with Distance Sensing Scan Tool Information
WARNING: This page is about a different car, the 2008 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
Distance Sensing Cruise Control Scan Tool Output Controls
| Scan Tool Output Control | Description |
|---|---|
| Factory Reset | The scan tool changes the adaptive cruise module (ACM) Auto Alignment Learn Status parameter from Aligned to Not Aligned. Once in the Not Aligned state, the vehicle must be driven at speeds of at least 56 km/h (35 mph) and find at least 40 acceptable targets in order to correct the auto alignment status to Aligned. |
| DSCC Setup (Japan Only) | The scan tool enables the Adaptive Cruise Module (ACM) to calibrate itself after ACM replacement. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.