Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G3500, VAN PASSENGER EXTENDEDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 201 (DISC BRAKE SYSTEM)REPAIR INSTRUCTIONSFRONT BRAKE CALIPER BRACKET REPLACEMENTINSTALLATION PROCEDURE

2008 Chevrolet Chevy Express G3500, Van Passenger Extended

Installation Procedure

2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Installation Procedure

WARNING: This page is about a different car, the 2008 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Brake Caliper Bracket & Mounting Bolts

Courtesy of GENERAL MOTORS CORP.

Install the brake caliper bracket (1) to the knuckle.

IMPORTANT: If reusing the caliper bracket bolts the threads of the caliper bracket bolts and the threads of the knuckle mounting holes must be free of residue and debris prior to application of threadlocker in order to ensure proper adhesion and fastener retention.

Prepare the bolts and the threaded holes for assembly:
1. Thoroughly clean the residue from the bolt threads by using denatured alcohol or equivalent and allow to dry.
2. Thoroughly clean the residue from the threaded holes by using denatured alcohol or equivalent and allow to dry.
3. Apply threadlocker GM P/N 12345493 (Canada P/N 10953488), or equivalent to 2/3 of the threaded length of the lower caliper bracket bolts. Ensure that there are no gaps in the threadlocker along the length of the filled area of the bolts.
4. Allow the threadlocker to cure approximately 10 minutes before installation.

NOTE: Refer to Fastener Notice .

Install the 2 brake caliper bracket bolts (2).
Tighten: Tighten the front brake caliper bracket bolts to 130 N.m (96 lb ft).

Fig 2: View Of Caliper Guide Pin Retaining Seat, Pin Boots & Boot Seal Retaining Seat

Courtesy of GENERAL MOTORS CORP.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.