Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G3500, VAN PASSENGER EXTENDEDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 199 (PROPELLER SHAFT)COMPONENT LOCATORDRIVELINE DISASSEMBLED VIEWS
2008 Chevrolet Chevy Express G3500, Van Passenger Extended
Driveline Disassembled Views
2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Driveline Disassembled Views
WARNING: This page is about a different car, the 2008 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
| Callout | Component Name |
|---|---|
| 1 | Mounting Flange Bolt |
| 1 | Mounting Flange Bolt |
| 2 | Mounting Flange |
| 2 | Mounting Flange |
| 3 | Propeller Shaft Rear Half |
| 4 | Mounting Flange Nut |
| 4 | Mounting Flange Nut |
| 5 | Propeller Shaft O-ring Seal |
| 6 | Center Support Bearing |
| 7 | Center Support Propeller Shaft Retaining Ring |
| 8 | Center Support Bearing Slinger |
| 9 | Dust Boot |
| 10 | Dust Boot Clamp |
| 11 | Propeller Shaft Front Half |
| Callout | Component Name |
|---|---|
| 1 | Front Propeller Shaft |
| 2 | Mounting Flange Bolt |
| 2 | Mounting Flange Bolt |
| 2 | Mounting Flange Bolt |
| 3 | Nut |
| 4 | Washer |
| 5 | Bolt |
| 6 | Heat Shield Bolts |
| 7 | Heat Shield |
| 8 | Center Bearing |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.