Removal Procedure

2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Removal Procedure
WARNING: This page is about a different car, the 2008 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the door trim panel. Refer to Rear Side Door Trim Panel Replacement or Front Side Door Trim Panel Replacement .
  2. Fig 1: View Of Door Control Module
    GM754067Courtesy of GENERAL MOTORS CORP.
  3. Remove the door control module (1) by releasing the retainer tabs (2).
  4. Fig 2: View Of Door Control Module Electrical Connectors
    GM754066Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the electrical connectors (1) from the control module (2).
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.