Air Quality Sensor Replacement

2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Air Quality Sensor Replacement
WARNING: This page is about a different car, the 2008 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Air Quality Sensor
GM1480372Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Radiator Support Sight Shield Retainer (Qty: 6)
2 Front Compartment Front Sight Shield Assembly
3 Radiator Grille Retainer (Qty: 4)
Tip:Β  By removing these 4 retainers allows the front fascia grille flexibility to be moved forward to access the air quality sensor.
4 Air Quality Sensor Connector
5 Air Quality Sensor Bolt
NOTE: Refer to Fastener Notice .

Tighten:Β  9 N.m (80 lb in)

6 Air Quality Sensor
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.