Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Audio Amplifier
The radio or digital radio receiver(routed through the radio), and OnStar® supplies low level audio signals to the audio amplifier in order to boost the signal sent to the speakers.
The radio uses the antenna input signal to create a stereo audio output signal, which is sent at the user-defined volume level to the audio amplifier. The audio amplifier amplifies the signal and sends it to the appropriate speakers. Tone, balance and fade information is sent by the radio to the audio amplifier via the GMLAN communication circuit. Additional output processing is provided by the noise-canceling microphone. The microphone monitors interior ambient noise allowing the audio amplifier to modify the audio output. This maintains the sound at an enjoyable level.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.