Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G3500, VAN PASSENGER EXTENDEDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 177 (INSTRUMENT PANEL TRIM AND CONSOLE TRIM)REPAIR INSTRUCTIONSINSTRUMENT PANEL CARRIER REPLACEMENTINSTALLATION PROCEDURE

2008 Chevrolet Chevy Express G3500, Van Passenger Extended

Installation Procedure

2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Installation Procedure

WARNING: This page is about a different car, the 2008 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Instrument Panel (I/P) Carrier Wire Harness Retaining Clips

Courtesy of GENERAL MOTORS CORP.

Connect the wire harness retaining clips to the rear of the carrier.

Fig 2: View Of Nuts Securing The Instrument Panel Carrier Brackets To The Pedal Assembly

Courtesy of GENERAL MOTORS CORP.

Locate the carrier on to the pedal assembly brackets.
Tighten: Tighten the nuts securing the instrument panel carrier brackets to the pedal assembly to 25 N.m (18 lb ft)

Fig 3: View Of Instrument Panel (I/P) Carrier

Courtesy of GENERAL MOTORS CORP.

Install the carrier to the vehicle.
Install the wire harness back into noted position.

Fig 4: View Of Fasteners Securing The Carrier To The Cowl

Courtesy of GENERAL MOTORS CORP.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.