Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G3500, VAN PASSENGER EXTENDEDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 170 (FIXED & MOVEABLE WINDOW SYSTEMS)REPAIR INSTRUCTIONSWINDSHIELD REPLACEMENTINSTALLATION PROCEDURE
2008 Chevrolet Chevy Express G3500, Van Passenger Extended
Installation Procedure
2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Installation Procedure
WARNING: This page is about a different car, the 2008 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
- Install the window into the opening. Refer to Adhesive Installation of Stationary Windows .
- Install the windshield side reveal moldings, if equipped. Refer to Windshield Side Reveal Molding Replacement .
- Install the outside moisture sensor if equipped.
- Install the Vehicle Direction Alert Alarm Warning (VDAAW ) Module. If equipped. Refer to Vehicle Direction Alert Alarm Warning Module Calibration .
- Install the rearview mirror. Refer to Inside Rearview Mirror Replacement (UE1) or Inside Rearview Mirror Replacement (DD7, DD8) .
- Install the interior windshield garnish moldings. Refer to Windshield Pillar Garnish Molding Replacement .
- Install the air inlet grille. Refer to Air Inlet Grille Panel Replacement .
- Install the windshield wipers arms. Refer to Windshield Wiper Arm Replacement .
- Remove the double layer of masking tape around the perimeter of the painted surfaces and the interior trim.
- Close the hood.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.