Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G3500, VAN PASSENGER EXTENDEDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 169 (EXTERIOR TRIM)REPAIR INSTRUCTIONSFRONT DOOR FRAME APPLIQUE REPLACEMENT

2008 Chevrolet Chevy Express G3500, Van Passenger Extended

Front Door Frame Applique Replacement

2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Front Door Frame Applique Replacement

WARNING: This page is about a different car, the 2008 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Front Door Frame Applique

Courtesy of GENERAL MOTORS CORP.

Callout

Component Name

Preliminary Procedure:
Remove the outer belt sealing strip. Refer to Front Side Door Window Outer Sealing Strip Replacement .

Front Side Door Applique

NOTE: Refer to Exterior Trim Emblem Removal Notice .

Tip:

The part and surface should be 21°C (70°F) prior to installation. The vehicle should remain 21°C (70°F) for one hour after assembly to allow adhesive to develop sufficient bond strength.
Use a J 25070 Heat Gun or equivalent to remove the old applique. Clean all the adhesive residue from the door and wipe the surface dry with a clean lint-free towel prior to installing the new applique.
When removing the 3 protective liners from adhesive backed applique, be careful not to touch the tape with hands and do not allow the tape to come in contact with dirt or any foreign matter prior to adhesion.
Press the applique firmly to the front side door to ensure full adhesion is made to the door.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.