Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G3500, VAN PASSENGER EXTENDEDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 155 (CRUISE CONTROL SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESDTC B3794CIRCUIT/SYSTEM TESTING
2008 Chevrolet Chevy Express G3500, Van Passenger Extended
Circuit/System Testing
2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Circuit/System Testing
WARNING: This page is about a different car, the 2008 Chevrolet Malibu Classic. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, remove the inflatable restraint steering wheel module. Refer to Inflatable Restraint Steering Wheel Module Replacement (Non-SS) or Inflatable Restraint Steering Wheel Module Replacement (SS) .
- Disconnect the harness connector at the steering wheel controls switch - left.
- Ignition ON, test for greater than 10 volts between the supply voltage circuit terminal 4 and ground.
- If less than the specified range, test the supply voltage circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the BCM.
- Verify the scan tool Cruise Control Switch parameter is OFF.
- If not the specified value, test the signal circuit terminal 5 for a short to voltage. If the circuit tests normal, replace the BCM.
- Ignition OFF, connect the harness connector at the steering wheel controls switch - left.
- Ignition ON, with the cruise control switch in the ON position, observe the scan tool Cruise Control Switch parameter. The parameter should display ON.
- If not the specified value, test the signal circuit terminal 5 for a short to ground, a short to voltage or an open/high resistance. If the circuit tests normal, test or replace the steering wheel controls switch - left.
- Observe the scan tool Cruise Control Switch parameter while pressing the RES + portion of the cruise control switch. The parameter should display Resume.
- If not the specified value, test or replace the steering wheel controls switch - left.
- Observe the scan tool Cruise Control Switch parameter while pressing the SET - portion of the cruise control switch. The parameter should display Set.
- If not the specified value, test or replace the steering wheel controls switch - left.
- Observe the scan tool Cruise Control Switch parameter while pressing the Cancel portion of the cruise control switch. The parameter should display Cancel.
- If not the specified value, test the cruise control cancel signal for a short to ground or an open/high resistance. If the circuit tests normal, test or replace the steering wheel controls switch - left.
- If all circuits test normal, test or replace the BCM.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.