SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G3500, VAN PASSENGER EXTENDEDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 154 (CONFIGURABLE CUSTOMER CONTROL SYSTEM)REPAIR INSTRUCTIONSSTEERING WHEEL CONTROL SWITCH ASSEMBLY REPLACEMENT (NON SS)
2008 Chevrolet Chevy Express G3500, Van Passenger Extended

Steering Wheel Control Switch Assembly Replacement (Non SS)

2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Steering Wheel Control Switch Assembly Replacement (Non SS)
WARNING: This page is about a different car, the 2008 Chevrolet Malibu Classic. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Steering Wheel Cruise Control Switches
GM1824224Courtesy of GENERAL MOTORS CORP.
Callout Component Name
CAUTION: Refer to SIR Caution .
Preliminary Procedure: Remove the inflatable restraint steering wheel module. Refer to Inflatable Restraint Steering Wheel Module Replacement (Non-SS) or Inflatable Restraint Steering Wheel Module Replacement (SS) .
1 Steering Wheel Control Switch Assembly Screw (Qty: 6)
NOTE: Refer to Fastener Notice .

Tip:  DO NOT over tighten the steering wheel control switch screws or damage to the switch(s) or steering wheel covers may occur.

Tighten:  2 N.m (18 lb in)
2 Steering Wheel Control Switch Assembly (Qty: 2)
Tip: 
  • Disconnect the electrical connector.
  • Make sure the steering wheel control switch(s) are properly seated to the steering wheel shroud during installation.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.