Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G3500, VAN PASSENGER EXTENDEDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 138 (REAR SUSPENSION SYSTEM)REPAIR INSTRUCTIONSSTABILIZER SHAFT REPLACEMENT (BASE SEDAN)INSTALLATION PROCEDURE

2008 Chevrolet Chevy Express G3500, Van Passenger Extended

Installation Procedure

2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Installation Procedure

WARNING: This page is about a different car, the 2008 Chevrolet Malibu Classic. However, it is still accessible from the selected car via links, so may be relevant.

Install the stabilizer shaft.

Fig 1: Identifying Stabilizer Shaft Bracket Bolts

Courtesy of GENERAL MOTORS CORP.

Install the stabilizer shaft insulators.
Install the stabilizer shaft brackets.

NOTE: Refer to Fastener Notice .

Install the stabilizer shaft bracket bolts.
Tighten: Tighten the stabilizer shaft insulator bracket retaining bolts to 35 N.m (26 lb ft).

Fig 2: Identifying Stabilizer Shaft And Knuckle Bolts

Courtesy of GENERAL MOTORS CORP.

Install the stabilizer shaft links to knuckle bolts.
Tighten: Tighten the bolts to 55 N.m (41 lb ft).
Install the toe link. Refer to Toe Link Replacement .
Lower the vehicle.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.