Installation Procedure

2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Installation Procedure
WARNING: This page is about a different car, the 2008 Chevrolet Malibu Classic. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Exploded View Of Washer Solvent Container
    GM1207514Courtesy of GENERAL MOTORS CORP.
  1. Position the washer pump seal (6) to the washer solvent container (1), pressing in until fully seated.
  2. Position the washer pump (5) to the washer solvent container (1) pressing in until fully seated.
  3. Connect the washer pump electrical connector.
  4. Connect the washer pump hose (2) to the washer pump (5)..
  5. Install the front fender liner. Refer to Front Fender Liner Replacement .
  6. Fill the washer solvent container with washer solvent.
  7. Inspect the washers for proper operation.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.