Vanity Mirror Replacement (w/Light)

2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Vanity Mirror Replacement (w/Light)
WARNING: This page is about a different car, the 2008 Chevrolet Malibu Classic. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Vanity Mirror Replacement (w/Light)
GM1642979Courtesy of GENERAL MOTORS CORP.
Callout Component Name
Fastener Tightening Specifications:Β  Refer to Fastener Tightening SpecificationsΒ .
Preliminary Procedure:Β 
Remove the sunshade. Refer to Sunshade Replacement .
1 Vanity Mirror Assembly
Tip:Β  Insert a plastic trim tool or finger tips at the tab locations to remove the vanity assembly from the sunshade.
2 Vanity Mirror Circuit Board
Tip:Β 
  1. Remove the circuit board from the vanity mirror assembly by flexing the vanity mirror enough to release the circuit board from the retaining tabs.
  2. Transfer circuit board to new vanity mirror assembly and route wire leads as shown.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.